Sanyo pro xtrax multiverse projector menu

Sanyo pro xtrax multiverse projector menu how to#

Once youРІР‚в„ўve got to this point, itРІР‚в„ўs time to begin dusting. Move these ribbon cables out of the way, like so. It will still be attached at the front so donРІР‚в„ўt try to remove it. Remove this screw and unplug these connectors.Р”Вisconnect the three ribbon cables by pulling these toggle gently outwards. Remove these screws, remove the air filters, then turn over and remove the top cover from back to front. Remove these two screws and CAREFULLY lift out the bulb. Remove this screw to open the bulb cavity.

The following photos are a guide to how to get this bugger apart: Proceed at your own risk, and do not come crying to me if you break your projector. Remember that this procedure is definitely not manufacturer-approved, so donРІР‚в„ўt screw it up and then try to claim on the warranty. My goal here was not to completely dismantle the projector, just to open it up far enough for easy access to the optical assembly, where dust ingress causes the most problem. IРІР‚в„ўd already tried cleaning dust out with compressed air via the side vents, but clearly it needed a more thorough job. I quickly found advice online that a РІР‚Сљblotchy uneven purple in the image is caused by dust contamination on the green LCDРІР‚Сњ.

I wasnРІР‚в„ўt convinced the new bulb was to blame, so I went looking for another explanation. I have a lot of these projectors, and after replacing a bulb on one of them recently, I found that the image was a bit blurry, and there was an uneven purple discolouration across the screen.

Sanyo pro xtrax multiverse projector menu how to#